Talk:Countersink

Metalworking Mid‑importance

	This article is within the scope of WikiProject Metalworking, a collaborative effort to improve the coverage of Metalworking on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.MetalworkingWikipedia:WikiProject MetalworkingTemplate:WikiProject MetalworkingMetalworking
Mid	This article has been rated as Mid-importance on the project's importance scale.

Woodworking (inactive)

This article is within the scope of WikiProject Woodworking, a project which is currently considered to be inactive.WoodworkingWikipedia:WikiProject WoodworkingTemplate:WikiProject WoodworkingWoodworking

Tip: Anchors are case-sensitive in most browsers.

This article contains broken links to one or more target anchors:

[[Screw#Types of screws and bolts|countersunk-head screw]] The anchor (Types of screws and bolts) has been deleted.

The anchors may have been removed, renamed, or are no longer valid. Please fix them by following the link above, checking the page history of the target pages, or updating the links.

Remove this template after the problem is fixed | Report an error

Untitled

I especially wouldn't mind comments on the cross hole deburrer desciption. I'm going by what I was taught and have learnt about there usage.-- Graibeard 06:25, 25 Mar 2005 (UTC)

I routinely use them for creating countersinks in aluminum and mild steel. They have much less chatter than the multi-flute ones.

--Pstemari (talk) 00:11, 12 November 2016 (UTC)[reply]

Countersink drill bits are missing in here.

Would be nice if they were included. Best regards, IP 77.13.189.200 (talk) 20:29, 27 July 2019 (UTC)[reply]